Review of the Evora Full Face Mask:
According to our criteria, full-face CPAP masks in this fashion do not extend past the centre of the nose. The Philips Amara View and the ResMed F30 are the main alternatives to the Evora. In comparison to its rivals, the Evora holds its own. Let us summarise the most important points.
- The Evora’s dynamic support technology consists of a floating seal with integrated stability wings. Because of this, the seal can rest comfortably on the user’s face when using a cpap masks. That creates an excellent seal with almost any pressure on the face.
- The seal stays in place thanks to the stability wings, and you have a lot of room to move around in. As a result, 91 percent of trial CPAP users found a good fit with the Evora full face.
- First-Rate Helmet—The Evora Full’s headgear is unquestionably the best available in the minimal contact field. To keep your head cool and comfy, the straps are made of VentiCool material. Extremely versatile and long-lasting.
- The Evora Full offers a variety of seal sizes, including X-Small, Small/Medium, and Large, all of which are compatible with the same fitpack. You can also get this mask in a Fitpack that includes the various sizes.
- The Evora’s design keeps the entire seal below the nose, so you can breathe normally from either your mouth or nose. There is no significance to what you can see. Put on your glasses and read a book or watch TV while wearing your mask in bed.
- The exhalation apertures on the front of the mask are located on the frame’s lower sides, not far from where the tube attaches. If your bedmate or CPAP mask user has an annoying exhalation draught, these ports will help direct the air elsewhere.
- Easy attachment and detachment of the headgear are enabled by the combination of simple clips and a quick attach snap.
- The Evora is not a cheap car since it was built to last. The seals and the headpiece are the most vulnerable components of a CPAP mask. These two components of the mask are sturdy and designed to last a long time.
Methods for Adjusting the Evora Full Face Mask
- Keep your headpiece in one hand and the front of the Evora frame with the other. Remove the helmet’s bottom clips.
- To wear the mask, first press the seal to your face, and then pull the headpiece down over your head. The seal needs to be placed below the nose.
- Attach the two bottom clips of the headwear to the structure.
- Carefully snug the helmet straps. We recommend beginning with the blue upper straps and working your way down. Do an even pull on both ends. Acquire a snug and secure fit.
- Put the Evora CPAP mask tube into the CPAP machine’s tubing and turn it on.
- Verify a good seal by making any necessary changes to the headwear. Make sure the headgear fits snugly on both sides.
Care for the Entire Face: The Evora
In spite of how simple it is, regular cleaning and maintenance of your Evora full face is essential. If you don’t keep up with the cleaning, the mask won’t work well and you could end up in the hospital.
There have been some horrible things observed with CPAP masks. You shouldn’t join their ranks. The total upkeep of your Evora can be broken down into weekly maintenance and daily cleaning.
Evora Full-Service Cleaning Once a Day:
In between uses, you should clean the mask’s metal frame and plastic tube. This calls for a combination of a mild soap and hot water. The Mask and its tubing must then be placed underwater.
Scrub them by hand until they appear spotless. After that, give the pieces a good soak in clean water to remove any remaining soap. Parts can be left out to dry in the air, and then reassembled and used. It’s not safe to leave them in the sun.
Deep Cleaning Evora Every Seven Days
The Evora’s headpiece may be removed and washed by hand once a week to keep it functioning well and looking great for a long time. You can shorten the life of the hat by washing it too often.
Similar to the Evora’s frame, cushion, and tubing, the Headgear and clips may be cleaned in the dishwasher. Make sure to let it air dry completely before putting it back together.
Pros and Cons of the Full-Faced Evora
Like any CPAP mask, the Evora has its pros and cons. Many of them vary widely from one CPAP mask user to the next. The effectiveness of a CPAP mask will vary greatly, for instance, between people with long, slender noses and those with short, broad ones. Consequently, you should treat our commentary with caution.
Pros of Evora:
- Superior headwear – the latest iteration from F&P just cannot be beaten. It lasts a long time, doesn’t hurt, and can be attached and detached quickly and easily. Quick attach snaps are a wonderful feature that make removing the headpiece for cleaning a breeze.
- Superior “side of nose” sealing is achieved by the “wings” that rise up along the sides of your nose, which block up the nasal passages and prevent air from leaking out. That’s an area where competing full-face Minimal Contact masks fall short.
- The Evora’s exhalation ports are positioned on both sides, near the foot of the seal, and face downward for quiet operation. This results in an extremely gentle exhale, which is beneficial for both the CPAP mask user and their sleeping companion.
- The mask’s frame is low to the ground, and the tube attaches at the base. This makes it possible for the mask’s front to be extremely discreet. This is a fantastic addition for side sleepers and those who toss and turn throughout the night.
Cons of Evora:
- Mascara tube is not very flexible – The tube that emerges from the front of the Evora is not particularly flexible and can be difficult to rotate. The only possible drawback is if you tend to shift around a lot when sleeping. For your information, I think the Amara View has the best mask tube.
- The seals can be difficult to remove; I don’t think the ordinary person will have too much issue with them, but I can see how it might be challenging for elderly CPAP mask users or those with poor dexterity. The Evora’s seal is particularly difficult to dislodge, as it snaps into place. Especially if it’s completely fresh.
- Stop making a “Small-Medium” size seal; I have no idea why F&P feels the need to produce a seal in two sizes. Please refer to it as either “Medium” or “Small.” In some cases, it might be a tremendous hassle to figure out a person’s phone size just by talking to them. Still, this is not a problem with how the thing works. Only chaos.